Panasonic KX-TA624. Параметры соединения и формат данных SMDR/CDR

Данные ниже соответствуют только программе Advanced PBX Data Logger и могут быть не применимы для других программных продуктов.

Parameter Default value
Baud rate 9600
Data bits 8
Parity none
Stop bits 1
Flow control Hardware

Default programming code for panasonic is 1234 or 0000 or 9999.

KX-TDA Series : KX-TDA30 KX-TDA50 KX-TDA100 KX-TDA200

Note: Our data logger cannot capture SMDR data through a USB port.

Open the KX-TDA Maintenance Console and go to:

Maintenance > SMDR

Outgoing Call Print: Print
Incoming Call Print: Print
Intercom Call Print: Print
Log-in/Log-out Print: Print
ARS Dial (Automatic Route Selection): Dial after ARS Modification
CallerID Print format: Name + Number
DDI/DID Print format: Name + Number
Secret Dial: Print dialled number
Privacy mode: Print Dialled Number
Date Format: YY-MM-DD - named as international format

Maintenance > Miscellaneous

RS-232C: Baud Rate: 19200
RS-232C: NL Code: CR+LF
RS-232C: Word Length: 8bit
RS-232C: Parity Bit: None
Error Log Information Print: Print

RS232 cable layout

System > Date & Time

Change the date and time to current ones.

KX-TD and KX-TA Series (newer)

Go to the main console (Extension 101) and put it to programming mode by moving the switch on the phone to programming position.
Press *#xxxx where xxxx if the password for programming. This is usually 1234 or 0000 or 9999. If you don't know the password then please contact the supplier.
[800] - RS-232C Communication Parameters: CR+LF, 9600, 8 bits, mark parity, 1 stop bit.
[801] - choose 0 (skip perforation)
[802] - incoming on and outgoing on
[803] - choose to print the speed dialing
[805] - choose account code report to be code or index.
[806] - choose English language reporting
move the programming switch to the original position

KX-TD and KX-TA Series (older ones)

The programming switch is located on the PBX unit - open the cover and you'll find it and move it to programming mode.
[23] - Duration time count star mode: instantly (can be configured in the software)
[24] - SMDR Communication Parameters: CR+LF, 1200 bps, 7 bits, mark parity, 1 stop bit, 66 lines per page, skip perforation 0.
[26] - Outgoing: ON, Incoming: ON
move the programming switch to the original position

Данные, извлекаемые PBX Data Logger

ОписаниеТип данныхИмя колонки
Время звонкаdatetimeCALL_TIME
Набранный номерstringDIALED_PHONE
Длительность звонкаdatetimeCALL_DURATION
Длительность звонка (с)integerCALL_DURATION_S

Замечание: Продукты и компании, указанные здесь используются только для обозначение и идентификации и могут быть торговыми и/или зарегистрированными марками соответствующих компаний.